I stuck a brass in a full length sizing die ( not enough lube) :-(. Does anyone know how to remove this stuck 7MM TEM MAG BRASS from the die without ruining the die? Any help will be appreciated!
Sent from my iPhone using Tapatalk
I stuck a brass in a full length sizing die ( not enough lube) :-(. Does anyone know how to remove this stuck 7MM TEM MAG BRASS from the die without ruining the die? Any help will be appreciated!
Sent from my iPhone using Tapatalk
What type of die?Originally Posted by Rrdswigert
Sent from my SM-J727V using Tapatalk
There is a Stuck Case Kit from RCBS. You can make a kit yourself at the local hardware store for right now, and it is cheap.
You need a Socket, 1/4 Drill Bit. 1/4x20 Tap, 1/4 x20 allen screw about 2" long, and a few washers.
The socket needs to just sit on the lip of the die, but be big enough for the case head to go inside the socket.
Drill the primer pocket out, thread the hole with the tap, put the socket on the die, screw goes through washer on the back of the socket.
Thread the bolt into the threaded case, and keep turning. It will extract the case with no problem
Lee Die
Sent from my iPhone using Tapatalk
That makes sense We’d. Thank you
Sent from my iPhone using Tapatalk
If has the decapping pin in it loosen the nut. Find a punch the same size or slightly smaller than the pin. Use the punch and hammer to drive the pin and brass out of the die. It will probably take some pounding to get it out. Quickest easiest way I know of.
Sent from my SM-J727V using Tapatalk
Codyspowell; it would have worked, however I drilled the primer hole out so now I am up a creek. I have to oversized the bolt I screw in there and also now I have to thread the primer end of the brass. It is a serious job, just because I got skimpy on resizing lube!
Sent from my iPhone using Tapatalk
It happens to us all .. I did it ONE time with 50BMG case .. had to the a galvanized cap and drill a hole thru it to make a puller similar to the RCBS tuck case remover .. It worked great
Gotcha! What are you using for lube?
Sent from my SM-J727V using Tapatalk
Lee resizing lube. I want to find a recipe for lanolin and isopropyl alcohol. Do you know of one? How much of each to mix and blah blah lol
Sent from my iPhone using Tapatalk
Posting Permissions
Reply With Quote